This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Find out more here.

Follow Us

Categories

Visaton Vox 301 - price per pair.

Visaton Vox 301 - price per pair.
Visaton Vox 301 - price per pair. Visaton Vox 301 - price per pair. Visaton Vox 301 - price per pair.
Product Code: Visaton Vox 301 - price per pair.
Reward Points: 0
Availability: Please Phone To Order
Price: £1,564.10
Ex Tax: £1,303.42
   - OR -   
free delivery

This is the largest of the Vox designs, employing a massive 12 inch bass driver along with high quality mid range and tweeter. This is a speaker for organ fans but also anyone who likes a large scale, dynamic sound which can really dig deep. VOX 301

Art. No. 5915

Characteristics and sound properties

The VOX 301 extends the high-end VOX series upwards. While the mid-to-high-range is the same as in the VOX 253, the TIW 300 8 Ohm has been chosen as the woofer for this model. As a result, while the excellent characteristics experienced in the mid-to-high range remain the same, the level accuracy and dynamics in the bass department have been increased and the lower limiting frequency reduced to a remarkable 23 Hz. The VOX 301 can, therefore, be seen as the VOX variant for high-volume aficionados who like to hear concerts at close to the original sound levels in large rooms.

Construction

At first sight, the construction of the VOX 301 looks complicated, which is why it is worth looking at each internal part individually first.

In the lower part of the cabinet, you can see the bass reflex tunnel, made up of the base and an upper board. In the middle, there are three cross-reinforcements to prevent resonance. At the top of the cabinet, behind the cut-out in the acoustic baffle for the mid- to high-range unit, is the enclosure required for the mid-range cone, made up of two wooden boards. Three 8 mm holes will have to be drilled in the rear wall of the mid-range chamber for the cables. They should not be drilled directly behind the driver because otherwise there will not be enough depth available for the wires behind the magnets. The holes must be well sealed afterwards.

Fitting the TIW 300 into the side is a special feature. The mounting board for the TIW 300 (400 x 352 with a 289 mm cut-out) itself is glued in place from inside behind the square cut-outs in the corresponding side-wall. This means that the bass driver can be recessed by 19 mm (19 mm = thickness of the boards). For optical reasons, and to enable the cloth-covered frame to be fitted exactly in place, the side-wall cut-out must be made extremely accurately. The frame can be made from a 12 mm board. The outer dimensions of the frame should be exactly 1 mm smaller than the opening in the side-wall all round. In this way, the frame is jammed in place by the fabric used to cover it and alternative fixing methods (wooden plugs) are not necessary.

Two triangular reinforcing pieces are installed between the front panel and side walls to provide the required rigidity at the front despite the broad bevel.

The frequency crossover unit is mounted on the side-wall behind the bass cut-out.

Inner damping

The damping uses one mat placed in the medium range cabinet. The remainder is evenly distributed throughout the cabinet. The area above the tunnel opening (at the rear of the front panel) up to the lower edge of the reinforcement remains free. If, as a result of the acoustics in the room, the low-range bass is too powerful, damping this area will have a corresponding effect on the overall bass output level.