Speaker selection

Speaker selector

Filter source-reviewed loudspeakers and drivers by type, size, electrical load and fitting requirements, then compare up to four models.Filter and compare Visaton speakers by the details you know.

A shortlist is a starting point: the right speaker also depends on your enclosure and how it will be used. Talk it through with Impact before choosing.

Your requirements

Search by model, part number, size or typeFilters update as you type; the search at the top of the page searches the whole shop.

Size and fitting details

Measure the outer frame, the cut-out opening and the available depth behind the mounting surface.

Mounting

Maximum frame width (mm)Matches either orientation, including a 90° turn. Check fixing holes and clearances.

Maximum frame height (mm)

Maximum overall body depth (mm)

Maximum rear mounting depth (mm)

Cut-out shape

Maximum round cut-out diameter (mm)

Overall body depth includes the front projection. Rear mounting depth is measured behind the mounting face. Dimensions describe the body shown in the drawing; allow extra space for terminals, cable bends and installation tolerances.

Match the opening shape. Limits allow a smaller opening and do not confirm an exact replacement fit; check the drawing and fixings.

Sensitivity (loudness)

Minimum sensitivity (dB at 1 W/1 m)Compares output for the same input power; actual loudness also depends on your enclosure and signal.

Waterproofing and IP ratings explained

Waterproofing depends on the type of exposure and how the speaker is installed. An IP rating does not mean protection in every situation.

Splashes: IPX4 or IP64: Protection against splashing water. IP64 also specifies dust-tight protection.
Water jets: IP65: Protection against water jets and dust. Also meets the splash requirement.
Temporary immersion: IP67: Protection during temporary immersion under test conditions, plus dust protection. Immersion ratings alone do not confirm splash or water-jet protection.
Immersion: IPX8: Protection under manufacturer-specified immersion conditions. Check the permitted depth and duration for the individual speaker.

The first character after IP describes dust protection; the second describes water protection. X means that protection is not specified.

These speaker ratings apply to the front with the specified sealed mounting. They do not automatically protect the rear or your whole enclosure. Discuss the exposure and mounting with us.

Includes confirmed higher protection for the same exposure. Ratings depend on the specified sealed installation.

Dimensions are in millimetres. Body depth is the driver envelope, not the required enclosure depth. Allow extra space for terminals, wiring, seals and moving parts.

Speakers with missing or conditional specifications appear separately under “Needs confirmation”. Check the drawing before ordering.

Select up to four speakers to compare.

Before choosing

Dimensions are in millimetres. Body depth is the driver envelope, not the required enclosure depth. Allow extra space for terminals, wiring, seals and moving parts.

Speakers with missing or conditional specifications appear separately under “Needs confirmation”. Check the drawing before ordering.

Part number 1301 · 8 Ω

AL 130

A 13 cm aluminium-cone low-midrange driver for the bass and midrange of three-way hi-fi systems.

Speaker type: Midrange drivers
Nominal speaker size: 13 cm / 5 inch
Frame (W × H): 153 × 153 mm
Rear mounting depth: 58 mm
Cut-out: 115 mm
Rated power: 60 W

No speakers match these limits